| | |  | Water Cooling | Home » » Zalman Super Thermal Grease ZM-STG1 | | | | | | | Description: | |
Zalman Super Thermal Grease ZM-STG1
Best Performance: Zalman Super Thermal Grease (STG) maximizes heat transfer by eliminating the minute air gap between the heat source and the heat sink caused by their irregular surfaces
Ease of use: The brush attached to the bottle enables easy application and also prevents unnecessary waste of grease.
Easy Storage: A sealed bottle keeps the grease fresh for longer time, which is necessary since the bottled quantity allows 10 or more times of use.
Specifications:
Type : Non-curing compound
Capacity : 3.5g
Specific Gravity : 2.86
Temperature Stability : -45¡ÆC to 150¡ÆC (-49¡ÆF to 302¡ÆF)
Thermal Conductivity : 4W/mK
Application Instructions:
1. Clear off particles or residue from the contact surfaces of the heat source and heatsink.
2. Shake well then apply on the contact surfaces of the heat source and heatsink.
3. Install the heatsink.
* After application, approximately 7 days of regular computer use will give optimal performance.
Notes:
1. Please keep the bottle cap tightly closed during the storage.
2. Use only as thermal grease. Keep out of the reach of children.
3. Avoid contact with skin and eyes.
4. Do not ingest or put into mouth. If ingested, get medical attention.
| | | Features: | |
• Capacity : 3.5g
• A sealed bottle keeps the grease fresh for a long time
• The brush attached to the bottle enables easy application and also prevents unnecessary waste.
| | | Product Details: | | | Product Length:
| 0.39 inches | | Product Width:
| 0.39 inches | | Product Height:
| 0.39 inches | | Product Weight:
| 0.08 pounds | | Package Length:
| 8.0 inches | | Package Width:
| 2.1 inches | | Package Height:
| 1.6 inches | | Package Weight:
| 0.1 pounds | | Average Customer Rating:
|  based on 5 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
Write an online review and share your thoughts with other customers.
2 of 3 found the following review helpful:
 Awesome productNov 19, 2009
My laptops fans where on a lot, and so I used this thermal paste, and compared it to arctic silver. The fans took forever to come on to cool down the cpu, and thats cause it didn't heat up as fast. The laptop was running smoother, quieter, and better. When the fan did kick on for the cpu it wasn't as loud cause it wasn't working as hard.
With the arctic silver the fans turned on sooner, but where quiet still. Zalman is better, but more expensive for a little amount.
Also lasted me about 2 years. Even in below zero temps. I had the cleaning stuff for the thermal paste on the cpu, and that stuff froze, but zalman still worked. I was going to a customers house, and left the zalman in the car with the thermal compound remover cause I didn't know if I would need it or not.
1 of 1 found the following review helpful:
Good choiceAug 30, 2009
It's _very_ easy to use and it works just fine. My system is overclocked by 20% and it's stable. For me this means that this grease does its job well.
4 of 4 found the following review helpful:
Finally! No more messy syringes! Feb 13, 2009
There is not a lot to say about this Thermal Paste. The Convenience of having a small brush to paste the grease brings a lot of ease in the process. I actually enjoyed doing it. It aided my Cooler Master V8 in dropping my CPU temp down 20C (from 52 to 32)
The amount is very little, though. If you're planning to go through a lot of heatsinks, it's recommended to buy a second or a third. I can't quite say whether its performance beats others like the Arctic Silver, but the application is definitely a thousand times easier.
6 of 6 found the following review helpful:
 works awesome, storage wise its terrible Jun 03, 2008
im a pc gamer and my processor is slightly over clocked...amd4400 X2 at 2.53GHZ and a Zalman am2 lives on top of it..along with that i also have two large zalman fans livig on top of 2 7950 BFG's- all of the gear has had this thermal compound on it for a year... performance wise the grease works great and will significantly drop the cpu temp, with the standard tape it was pushing 50c, with the thermal compound it dropped it to 30c, over time the cpu likes to sit at around 33-35 constantly with full load..same deal for the cards, they were around 53C before and then 37-40c afterwards..
1.the good: the grease is a liquid that can be brushed on..
application is super easy-and the grease comes off easy too..
2.the bad: grease does not keep over time-dries out and hardens in the bottle in about 6 months..even with the lid shut tight....
in the past i have used artic sliver..and all the others..by far..i like this one the most..primarily for its easy ability to be applied..but having it dry out on me..is a real bummer..and its happened to me twice!..
3 of 3 found the following review helpful:
 Applies easily with the included applicator brushNov 30, 2007
Product image is accurate.
Product seems to work fine for my CPU and GPU, but I don't over-clock.
It applies smooth like finger nail polish and easy to spread evenly with the included applicator brush. The other thermal paste I have used applies like a paste instead of a thick liquid like this. The only downside is you only get enough fluid for about five full applications.
| | |
|
