| | |  | RAID / Multiple Drive Enclosures | Home » » » Coolerguys Dual 80mm USB Powered Cabinet Cooler for Cabinet & Home Theaters | | | | | | | Description: | |
Coolerguys Dual 80mm USB Powered Cabinet Cooler Bracket and Fans kit for Cabinet & Home Theaters
This 80mm Dual USB version of our Cabcool cooling kits is a great selection if you just want a no nonsense easy to install kit to keep your stuff cool. To use this kit you will need access to a USB port. We paired our silent 5 volt USB fans with our popular Dual 80mm Cabinet Bracket so you can power it from a standard computer USB or unused entertainment or stereo device that has a USB outlet.
This is a complete kit for a dual fan unit that will quietly cool your cabinet or multimedia center.
Can be mounted on any side of a cabinet, where room permits, by cutting a hole approximately 3/4" smaller on all sides of the outside bracket.
Insert completed cooler assembly in hole and attach to cabinet with appropriate screws.
Fan(s) can be set to blow into or out of the cabinet depending on your needs.
Cooling Unit includes the following:
(1) Set of Dual 80mm component cooling fans with USB connection
(1) Black Acrylic Fan bracket (8.00" x 4.25" x .125")
(4) Black 80mm fan grill
(8) Fan Screws to attach grill(s)
Pack - 4" Nylon Multi-Purpose Tie Black
(4) 1/2" black Cabinet screw(s)
All necessary screws, cables, and fasteners to complete the unit are included
Completed dimensions: 8.00" x 4.25" x .125"
Fan Specifications:
Dimensions: 80x80x25mm
Rated Voltage: 5 Volts
Connector: USB
Tail: 16 inch /Dual
RPM: 1500 +/- 10%
CFM: 20
dB: 19.7
Bearing: Sleeve
MTFB: 30,000 hrs
General Instructions for CabCool Cabinet Cooler Kits (574 kb pdf)
Note: This kit is not expandable and cannot be used with our thermal controller.
| | | Features: | |
• Power the fans from a USB port
• Super quiet, only 19.7 dB
| | | Product Details: | | | Product Length:
| 8.0 inches | | Product Width:
| 0.13 inches | | Product Height:
| 4.25 inches | | Product Weight:
| 1.0 pounds | | Average Customer Rating:
|  based on 8 reviews |
| | | | Customer Reviews: | |
Average Customer Review:
 ( 8 customer reviews )
Write an online review and share your thoughts with other customers.
Most Helpful Customer Reviews
Works as designedNov 03, 2011
By M. Wynia
I purchased this to go in the cabinet at church that houses our computer for our big screen. The cabinet was always warm inside. Once I installed this, it is not as warm anymore.
Assembly was easy, just make sure to have the fans point the correct way before you install this. It will save you having to take it back out and re-install it.
What I like about this is that it runs on the USB from the computer, so when the computer is off, this is off, and likewise when the computer is on, this is on. I don't have to worry about someone forgetting to start or stop it.
 Solved heat problemNov 02, 2011
By Madge
New desk required CPU enclosed which created excessive heat. This Powered Cooler solved the problem. Trapped heat is no longer an issue. Easy to install and powered by USB is a plus.
A little noisy, but a decent kit overall.Nov 02, 2011
By kannibul
It's a bit noisier than I'd like - kind of rattles - I can hear it when nothing else is on and I had it plugged into my XBox360, which the USB port on it runs all the time.
I fixed that by getting a USB extension cable, and plugging it into my reciever (Sony STR-1020, recently purchased from Amazon), since it powers the USB port only when turned on....I don't hear it now.
Seems to move enough air to get the job done, though I've yet to play my XBox since installing it simply due to a lack of free time, so I can't say that it'll do the trick with absolute confidence, but I'm very certain that it will.
I installed this into a TechCraft XLN62 TV Stand/Console/Cabinet that I'd recently purchased - even though it's well designed and has vents through the bottom, back and shelves, the air doesn't move well as the heat rises and stops against the top, and has no where to go...it would get pretty hot in there - hotter than I'd like. I had to trim the back panel to make it fit (thanks Dremel!) and then reinstall the fans so they blow out instead of in, install the finger guards, and screw it to the back panel/cabinet. Looks like it belongs there, so I'm happy with my ability to install it ;)
Short of that, it's a pretty straight forward, and it should do the trick. I think it was worth the money...
Smooth & QuietMay 30, 2010
By Jared1651
I used the fan for a custom desk I am building to house an always on desktop. Even with some vent ports I was worried about heat buildup. Installed the fan to exhaust the air next to the PC. Makes almost no sound when installed correctly and seems to do what I wanted.
 Nifty little fanApr 14, 2010
By G. Roskos
"mrg8415"
These fans have been a pretty good purchase. I am using them to ventilate a decent amount of space (~11 cu. ft. per unit, I have 4 units) and they have done a pretty good job of dropping the temperature a couple of degrees. One of the fan grills that was sent was for a 120mm face so that was a little frustrating. Also the screw holes in face plate where you mount the fans were not properly aligned so I had to bore them out a little bit more to get the fans mounted to the plate. I have had the fans for about a month now and they are on for about 8 hours a day everyday and they are still going strong.
See all 8 customer reviews on Amazon.com
| | |
|
